CASH & CARRY NOW OPEN 8 AM - 4:30 PM - Mask Required
1110 Curable Reducer
lowers the viscosity of plastisol inks without affecting the fusing
characteristics. This product is non-phthalate.
When adding reducers to
any plastisol ink, use a minimal amount of reducer to help maintain opacity.
The recommended proportion of 1110 reducer to ink is 1% to 10% by weight.
Note that the 1110
reducer should not be used in low bleed inks as it can lower the bleed
resistance of those type inks.
This product has only
been tested with International Coating’s inks. If this product is used with
another manufacture’s products, proper testing must be done to help insure the
performance and durability of the mixed product. The use of a curable reducer
is highly recommended for general use when adjusting the viscosity of plastisol
Products that are
designated as curable reducers will fuse or cure by themselves with the
application of proper heat and time. The use of a curable reducer is highly
recommended for general use when adjusting the viscosity of plastisol inks
because these curable reducers and modifiers can fuse or cure by themselves
with the proper application of heat and time. This means that if too much of
the curable reducer or curable modifier is added, the mixed ink will still fuse
The more curable reducer
or curable modifier added, the more the opacity of the mixed product will be