Open Mon-Fri, 8-5 PM PST with limitations. Learn More
Considerations in Mask Printing – Learn More
Item Number: INT-3816-5GAL
This item has an additional Handling Fee of $25.50 at check out.
3816 Sentri Clear™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing should occur in the dryer.