CASH & CARRY NOW OPEN 8 AM – 4:30 PM – Mask Required
Item Number: INT-7014-GAL
7014 Legacy White™ will spot dry, with a very low after ash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should just dry to the touch, with no lift off, but not totally fused. Totally fusing the underprint white may cause inter-coat adhesion problems with the inks printed on top of the white ink. Final fusing or curing occur in the dryer.