Quick Shop
Sales & Support 1-800-967-4070
Limited Free Shipping on Orders Over $200*

Open Mon-Fri, 8-5 PM PST with limitations. Learn More

Considerations in Mask Printing – Learn More

7043 GUARDIAN GRAY™ 5 GAL* Has an Additional Handling Fee
7043 GUARDIAN GRAY™ 5 GAL* Has an Additional Handling Fee

7043 GUARDIAN GRAY™ 5 GAL* Has an Additional Handling Fee

7043 GUARDIAN GRAY™ 5 GAL* Has an Additional Handling Fee

Item Number: INT-7043-5GAL

Out of Stock

This item has an additional Handling Fee of $25.50 at check out. 

Freight Policy

  • 7043 Guardian Gray™ blocks dye migration on problem fabrics that contain polyester, including sublimated dyed fabrics.
  • 7043 Guardian Gray™ can take a variety of topcoats depending on the application; from low cure products to regular temperature curing products.
  • 7043 Guardian Gray™ offers superior bleed resistant properties, but on some problem fabrics, it may be possible for bleeding or dye migration to occur.

7043 Guardian Gray™ will spot dry, with a very low after ash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing should occur in the dryer.

Always test for possible dye migration before beginning a production run. Bleeding or dye migration may not occur right away. Adding any reducers or additives can lower the bleed resistance, opacity, or increase cure times of ink. STIR the ink prior to printing on press and after the addition of reducers or additives. Test dryer temperatures and wash test printed product before and during a production run.

For best print and blocking results, print two passes of 7043 Guardian Gray™ through a 110 mesh screen. Then in sequence, Print-Flash-Print-Top Coat using a low bleed white ink or another type of low bleed performance ink.

MSDS Sheet

Related Items
Feature 11
Shipping & Crating
Recently Viewed Items