AMAGIC Textile Heat Press Foil - Gun Metal Silver SD - 12.5" x 200'

Application Settings:

1. Screen print your image with foil adhesive
1. Mesh count should be between 60 (24cm) and 110 (43 cm);
2. Smart tip: make sure your screen is at proper tension;
3. Smart tip: a thicker than normal EOM stencil will result in better coverage;
4. Smart tip: mix your adhesive thoroughly to soften before adding to the screen;
5. Smart tip: sheer (don’t push) the adhesive through the screen.
2. Suggested Print Processes:
1. Print > Flash > Print > Smoothing Screen or;
2. Two print strokes > smoothing screen.
3. Place the textile foil, color side up, over the area chosen to be foiled.
4. Using the above heat press settings, transfer the foil.
5. Use a soft cloth to rub the foil lightly and then peel the foil away, warm or cold peel.

This is a typical transfer process. We recommend you test the suitability of our foil for the field of application intended and under the transferring conditions at your facility. Adjust appropriately until desired results are achieved.