Open Mon-Fri, 8-5 PM PST with limitations. Learn More
Considerations in Mask Printing – Learn More
Item Number: AVI-K2944-5G
This item has an additional Handling Fee of $25.50 at check out.
K2944 THICKENER #3: Highly concentrated liquid thickener to increase viscosity and body of
plastisol inks. Mix Thickener #3 at 0.5 - 1% by weight (MAXIMUM) . Be sure to weigh the amount precisely, as an over addition can dramatically reduce printability. Stir thoroughly using a low sheer mechanical mixer or by hand. Do not over mix to the point of creating friction (high heat) as it could cause the plastisol to gel causing lumps. After mixing, wait a minimum of 2 hours before printing or testing for viscosity.